LG Refrigerator Error Codes: What They Mean and How to Fix Them

Your LG refrigerator beeps and shows Er IF, Er FF or Er dH where the temperature should be. LG fridges run self-checks on their fans, sensors, defrost system and boards, and the display tells you which one failed the check. Some codes clear after a power reset or a manual defrost. Others mean a fan motor, sensor or heater needs to be replaced. Here is what the common codes mean and what to do next.

Call Now – (650) 459-7977
  • Open 24/7
  • Fast response
  • Upfront quotes
  • All major brands
Infographic listing common LG refrigerator error codes such as Er IF, Er FF, Er dH and Er CO with what each one means, for Mountain View homes

What does an LG refrigerator error code mean?

An LG refrigerator error code is a message from the main control board that one of its parts did not pass a self-check. Most codes start with Er followed by two letters or numbers, like Er FF for the freezer fan or Er rS for the fridge sensor. Some models flash just the two letters. The code names the part to check first.

The display usually shows the code in place of the temperature, often with a beep. The fridge may keep cooling for a while, but a fan or defrost code means it will slowly warm up. Write the code down or take a photo before you reset anything.

What do the 12 most common LG refrigerator codes mean?

The codes we see most in Mountain View kitchens are fan codes (Er IF, Er FF, Er CF), sensor codes (Er rS, Er FS, Er dS, Er HS), the defrost heater code (Er dH), the water flow code (Er gF), the communication code (Er CO), the compressor relay code (Er 22) and demo mode (OF F). Fan codes are often caused by ice.

CodeWhat it usually meansTry first
Er IFIce maker fan not spinning rightCheck for ice around the fan, manual defrost
Er FFFreezer fan problemListen for the fan, clear ice, keep vents open
Er CFCondenser fan problem (bottom back)Unplug, clean dust and lint from the fan area
Er dHDefrost heater circuit openLook for frost on the freezer back wall, then call
Er rSRefrigerator sensor faultReset power once, then call
Er FSFreezer sensor faultReset power once, then call
Er dSDefrost sensor faultReset power once, then call
Er HSHumidity sensor faultReset power, the fridge often keeps cooling
Er gFWater flow sensor issueCheck the water valve and filter, look for a kink
Er CODisplay and main board not talkingReset power for 1 minute, then call
Er 22Compressor relay or start problemDo not keep resetting, call a technician
OF FDemo or display mode, cooling is offTurn demo mode off with the button combo

Codes can vary a little between French door, side-by-side, bottom freezer and InstaView models. The tech sheet is often tucked behind the bottom grille or inside the fresh food side. Kenmore Elite fridges built by LG use many of the same codes.

Why do fan codes like Er IF and Er FF keep coming back?

Fan codes most often come back because ice forms around the fan blade and stops it. That ice is usually a sign the defrost system is not melting frost the way it should, or that warm air is getting in through a door left ajar or a torn gasket. A manual defrost clears the ice, but the cause needs fixing or the code returns in days or weeks.

  1. Move food to a cooler and unplug the fridge.
  2. Leave the doors open for 12 to 24 hours with towels on the floor to catch melt water.
  3. Check that the door gaskets seal and nothing blocks the doors from closing.
  4. Plug back in and listen for the fans when the doors are closed.
  5. If the code returns, book a repair for the fan motor or the defrost system.

On many LG French door models, the ice maker in the fresh food door is a known weak spot. Frost buildup in the ice compartment, ice clumps and Er IF often show up together.

What should you do about Er CF and a warm fridge?

Er CF means the condenser fan at the bottom back of the fridge is not running right. Unplug the fridge, pull it out, remove the rear lower cover and clean dust and pet hair from the fan and coils. Make sure nothing blocks the blade. If the fan still does not spin when power is back on, the motor has likely failed.

A failed condenser fan makes the compressor run hot. You may hear the compressor running nonstop while the fridge warms up. Do not leave it that way for days, because heat stress can shorten compressor life. For a fridge that is warm and loud, call soon.

Which LG codes mean a part has failed?

If a code returns after a power reset and a manual defrost, a part has likely failed. Er dH, the sensor codes (Er rS, Er FS, Er dS) and Er CO almost always need a technician to test the part with a meter. Er 22 points to the compressor start circuit and should not be reset over and over. Call right away if food is warming.

Most refrigerator repairs in Mountain View cost about $200 to $600 with parts and labor, and ice maker repairs run about $150 to $400. The diagnostic visit is about $95 to $150 and is often credited toward the repair. Our team for LG refrigerator repair in Mountain View works on LG, Samsung, Whirlpool, GE and built-in brands.

How do you keep LG fridge codes from coming back?

Keep the doors closed and sealing, clean the condenser fan area once or twice a year, change the water filter on schedule, and do not pack the freezer so full that it blocks the vents. These steps prevent most fan, defrost and water flow codes. Leave the fridge a few inches of space at the back for air flow.

  • Check the door gaskets every few months. A dollar bill should not slide out easily when the door is closed.
  • Do not block the air vents inside the freezer and fresh food sections.
  • Change the water filter about every six months. Mountain View's hard water wears it faster.
  • Keep the kitchen floor under and behind the fridge clean and free of pet hair.

We repair LG refrigerators across Mountain View, ZIP codes 94040, 94041 and 94043, from apartments near Castro Street and the Mountain View Caltrain station to homes in Old Mountain View, Cuesta Park, Monta Loma and Waverly Park.

Other common repairs we see in Mountain View

Two more questions we get every week: why an oven is not working but the stove is, and why a dryer turns off after a few minutes of running.

Frequently asked questions

How do I reset an LG refrigerator error code?

Unplug the refrigerator or switch off its breaker for about one minute, then restore power. Many codes clear if the fault was a one-time glitch. If the same code comes back within a day, the part it names needs checking.

What does Er IF mean on an LG refrigerator?

Er IF points to the ice maker fan in the freezer or the ice compartment. Ice buildup around the fan blade is the most common cause. A manual defrost can clear it for a while, but if it returns, the fan motor or the defrost system needs repair.

What does Er dH mean on an LG fridge?

Er dH means the defrost heater circuit failed its check. The heater, a defrost sensor or a fuse may be open. You will often see frost building on the back wall of the freezer and the fresh food side getting warm.

Why does my LG fridge say OF F?

OF F means the refrigerator is in display or demo mode. The lights and display work but the cooling is off. On most models, hold the Refrigerator and Ice Plus buttons together for about five seconds to turn demo mode off.

How much does LG refrigerator repair cost in Mountain View?

Most refrigerator repairs in Mountain View cost about $200 to $600 with parts and labor. Ice maker repairs run about $150 to $400. The diagnostic visit is about $95 to $150 and is often credited toward the repair.

Is it worth fixing an LG refrigerator with an error code?

Usually yes when the fridge is under about 10 to 12 years old and the code points to a fan, sensor, heater or ice maker. If an older fridge needs a compressor or sealed system work, compare the quote with a new refrigerator first.

Live 24/7 · Mountain View, CA

Talk to an appliance technician now

Tell us what your appliance is doing. We will quote the visit on the phone and book the first open slot, often the same day.

  • Upfront price before any work
  • All major and luxury brands
  • Fridge and leak calls go first

More appliance repair guides

Need an appliance fixed today?

Call now to talk to a real person, any time of day or night.

(650) 459-7977 Call Now – (650) 459-7977

Our appliance repair services in Mountain View

One call covers every major appliance in your home. Pick a service for signs, costs, and how the repair works.

Call Now – (650) 459-7977